AbleNet QuickTalker 7

To Next Page

Key Features Step 1 - Powering QuickTalker

™

Step 2 - Select Level Step 3 - Recording Messages

Quickstart Guide

QuickTalker

™

QuickTalker

™

QuickTalker

™

a) Entering Record Mode

Press and hold the RECORD button on the back of device

until the red light is on, then release.

Select Level

Select LEVEL (1-5) by pressing the red button on the

front of the device.

Powering QuickTalker™

Turn the device to the back side. Insert 4 AA batteries

into the device where shown. Use the On/Off switch to

power the device.

b) Recording Messages

Press and hold the desired message location, begin

speaking after the beep, then release. Repeat for other

locations.

Tip! Speak 6-8” from the microphone for loud, clear sound.

c) Exiting Record Mode

Press and release the RECORD button. Lights turn off.

Note: The device will automatically exit Record Mode

after 20 seconds of no activity.

Level Selection

Volume

Adjust

Buttons

Level Indicators

Recording Indicator Light

Symbols

Overlay +

Storage

Full Length

Handle

Individual

Message

Locations

Core Message

Locations

Speaker

Power On/Off

Record Button

Battery Compartment

Power On/Off

Battery Compartment

Level Selection

Level Indicators

Record Button

Recording Indicator Light

Need help?

Do you have a question about the AbleNet QuickTalker 7 and is the answer not in the manual?

Summary

Key Features

Powering QuickTalker

Powering Process

Turn device to back, insert 4 AA batteries, use On/Off switch to power.

Select Level

Level Selection Method

Select LEVEL (1-5) by pressing the red button on the front of the device.

Recording Messages

Entering Record Mode

Press and hold the RECORD button on the back until the red light is on, then release.

Recording Audio

Press and hold message location, speak after beep, then release. Recommended distance: 6-8 inches.

Exiting Record Mode

Press and release RECORD button; lights turn off. Auto-exit after 20 seconds of inactivity.

Playing a Message

Message Playback

Press the desired location to play a message. Pressing another location stops current message.

Volume Adjustment

Press the gray arrow buttons to adjust the volume.

Message Light Indicator

Record light flashes yellow for blank, red for recorded location.

Erasing Messages

Single Location Erase

Enter Record Mode, then quickly press and release the location.

Level Erase

Hold RECORD for 10 seconds; clears all messages on current level. Core messages remain.

Master Clear

Hold RECORD for 30 seconds; clears ALL QuickTalker messages.

Advanced Features

Core Messages

Three core messages are the same for all levels; last recorded messages are played.

Locking Controls

Press RECORD & LEVEL simultaneously for 5 seconds. All lights flash twice to lock/unlock.

Warranty and Care

Cleaning Instructions

To clean, wipe with a slightly damp cloth.

Product Warranty

Two-year limited warranty against defects in materials and manufacturing.

Further Information

Find warranty, guarantee, and return/repair info online. Contact for product/service info.