Färsbifformande maskin - Patty forming Machine
23
3- INSTALLATION - INSTALLATION
• För modellen HD3000
• Placera bandet runt strukturen
och spänn det genom att trycka
ned det som figuren visar
• För in strukturen i styrstiftet
• Placera i mitten
• Skruva handtaget
• Collegare il cavo di
alimentazione elttrico del
nastro nell’apposita presa
posta sul lato destro e ruotare
l’interruttore su 1
• For mod. HD3000
• Place the tape around the
structure and pull toght by
lowering the locking as shown
in figure
• enter the structure in the guide
pin
• place it in the center
• screw the knob
• connect the power cord electric
tape into the socket on the right
side and turn the switch to 1
To Next Page