EasyManua.ls Logo

Above All VISION LED STRIP User Manual

Default Icon
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Add: 1501 Industrial Way N, Toms River, NJ 08755 Phone: 866-222-8866 E-mail: info@abovealllighting.com
Web: www.aboveallLighting.com ©2016 ABOVE ALL. Inc. All rights reserved
VISION LED STRIP
Instructions Manual
1
READ CAREFULLY BEFORE INSTALLING FIXTURE. PLEASE KEEP THIS MANUAL FOR FUTURE USING.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED.
MAKE CERTAIN POWER OFF BEFORE INSTALLING OR MAINTAINING FIXTURE.
CHECK THAT VOLTAGE IS COMPATIBLE WITH FIXTURE DRIVER, USE APPROVED CONNECTORS FOR
ALL ELECTRICAL CONNECTIONS.
WARNING:
SUITABLE FOR MODEL
WIRE CONNECTION
RISK OF ELECTRICALSHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring xture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code and any applicable
local code requirements.
All wiring connections should be capped with UL approved wire connectors.
SAFETY INSTRUCTION:
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing or
performing maintenance.
Avoid direct eye exposure to the light source while it is on.
Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Keep combustible and other materials that can burn away from luminaire and lamp/lens.
• MIN 90°C SUPPLY CONDUCTORS.
WIRE CONNECTION
Universal voltage driver permits operation at 120V thru 277V, 347V, 50 or 60Hz
a. Connect the voltage supply Line to our AC-L lead
b. Connect the voltage Neutral supply to our AC-N lead
c. Connect the green/yellow ground lead to the supply ground lead
Question and Answer IconNeed help?

Do you have a question about the Above All VISION LED STRIP and is the answer not in the manual?

Above All VISION LED STRIP Specifications

General IconGeneral
BrandAbove All
ModelVISION LED STRIP
CategoryLantern
LanguageEnglish

Summary

SAFETY INSTRUCTIONS AND WIRING

ELECTRICAL SHOCK WARNING

Safety instructions to prevent electrical shock during installation and maintenance.

INJURY PREVENTION CAUTIONS

Advice on using protective gear and avoiding light exposure.

FIRE RISK CAUTIONS

Precautions to prevent fire hazards, keeping combustibles away from the luminaire.

WIRE CONNECTION

Instructions for connecting the universal voltage driver to the AC supply leads.

INSTALLATION PREPARATION

DIMENSION DRAWINGS

Diagrams showing fixture dimensions for 4FT, 3FT, and 2FT models.

SURFACE MOUNTING OPTIONS

SURFACE MOUNT

Instructions for direct surface mounting the luminaire.

QUICK SURFACE MOUNT

Steps for quickly mounting the luminaire using hanger brackets.

CHAIN MOUNT

CONTINUOUS RUN MOUNT

MICROWAVE SENSOR SETTINGS

ON/OFF SENSOR SETTING

Configuration of detection area, hold time, daylight sensor, and mode.

DIMMING SENSOR SETTING

Configuration of detection area, hold time, stand-by period, daylight sensor, and dimming level.