What to do if Abrelex UPS is beeping and the battery LED is orange?
If the Abrelex UPS is beeping once every 4 seconds and the battery LED is orange (Code: E062), it means a utility failure has occurred, and the UPS is in battery mode. The UPS is currently using battery power to keep your equipment running. You should prepare your equipment for shutdown.
Lists safety and EMC certification standards for the UPS.
Explains symbols used on the UPS for warnings and information.
Addresses voltage backfeed risks, grounding requirements, and personnel safety.
Details safe handling of batteries, including toxic material warnings and PPE.
Stresses following connection and operation instructions in the indicated order.
Advises on overcurrent protection requirements for fire risk reduction.
Provides advice on handling heavy units, storage, and battery charging for longevity.
Emphasizes using identical battery modules for replacement to maintain performance and safety.
Explains the product's eco-design approach and substance compliance.
Shows illustrations of the front panels for Tower and RT UPS models.
Illustrates and labels the rear panels of various Tower UPS models.
Advises on inspecting equipment for shipping damage and safely unpacking the UPS units.
Provides installation instructions for the Tower UPS model, including placement and stabilizer bracket.
Specifies recommended circuit breakers, cable sizes, and isolating devices for connection.
Details connection procedures for qualified personnel, including safety checks and grounding.
Covers pre-installation steps, wiring preparation, and secure cable connections for parallel systems.
Guides on regulating and checking output voltage differences between parallel UPS units.
Provides requirements for output wiring length differences in parallel systems.
Details steps for adding a new UPS to an existing parallel configuration.
Provides step-by-step instructions for safely removing one UPS from a parallel setup.
Guides on safely shutting down and removing all UPS units from a parallel system.
Describes the UPS graphical LCD, five-button interface, and button functions.
Lists user-configurable settings like password, language, voltage, and power strategy.
Guides on starting the UPS using utility or battery power.
Explains procedures for shutting down the UPS with or without utility power.
Lists control options like battery test, fault reset, and factory settings restoration.
Lists user-configurable settings including password, alarms, voltage, and frequency.
Describes RS232/USB ports, EPO, Dry In/Out functions, and simultaneous operation limits.
Provides guidelines for cleaning, maintaining, and properly transporting the UPS.
Details recommendations for storing the UPS for extended periods, including battery charging.
Details critical safety warnings and precautions for battery replacement.
Provides specific instructions for replacing Extended Battery Modules (EBMs).
Lists common alarms, faults, their causes, and corrective actions.
Lists model numbers and their corresponding power ratings.
Table showing weights and dimensions for UPS and EBM models.
Details electrical input specifications like frequency range and bypass voltage.
General| Capacity | 600 VA / 360 W |
|---|---|
| Input Voltage | 230 VAC |
| Typical Recharge Time | 4-6 hours recover to 90% capacity |
| Operating Temperature | 0-40°C |
| Output Voltage | 230 VAC |
| Output Frequency | 50/60 Hz ±1 Hz |
| Battery Type | 12V/7Ah |
| Protection | Overload |
| Communication Interface | USB |
To Next Page