ABRITES MERCEDES FBS4 MANAGER

Need help?

Do you have a question about the ABRITES MERCEDES FBS4 MANAGER and is the answer not in the manual?

Summary

1. Introduction

2. General Information

2.1 Scope of the manual

Defines the manual's applicability and scope for the latest software version.

2.2 Getting Started

Provides instructions on how to launch the Abrites Mercedes FBS4 Manager application.

3. FBS4 Manager

4. ECU Replacement

4.1 Engine Control Unit (ECU) replacement procedure

Details the specific steps for replacing Engine Control Units, including virginization and personalization.

4.2 Connections

Lists the required connections for working with ECUs in the vehicle and on bench.

4.3 Virginization procedure

Explains how to set an ECU to virgin state for personalization, both in vehicle and on bench.

4.4 Read FBS4 Personalization Data

Describes how to read personalization data from ECUs via OBDII or on bench.

4.5 ECU BENCH DIAGRAMS

Provides pinout diagrams for ECU bench connections.

4.6 MRD1;MRG1 ECUs - CB030 - Mercedes-Benz MD;MG ECU connection cable

Details the use of the CB030 cable for bench connection with MD1/MG1 ECUs.

4.7 Requirements

Lists the necessary licenses and hardware components for ECU operations.

4.8 VIN Exchange

Explains the procedure for exchanging the VIN on ECUs.

5. TCU Replacement

5.1 Transmission Control Unit (TCU) replacement procedure

Details the procedure for replacing TCUs, including data transfer and calibration.

5.2 Connections

Lists the connection methods for various TCU types, including bench connections.

5.3 VGSNAG3 9 G-tronic

Describes the connection for the VGSNAG3 9G-tronic TCU using DS Box and CB403.

5.4 VGS2-DCT Mercedes VGSNAG2-FDCT

Details the connection for the VGS2-DCT Mercedes VGSNAG2-FDCT TCU.

5.5 VGS4 NAG2 7-G Tronic

Explains the procedure for VGS4NAG2 units, including mechanical work and ABProg programmer.

5.6 Requirements

Lists the required licenses and sets for working with VGSNAG3, VGS-DCT, and VGS4NAG2.

6. ESL (ELV) Repair

6.1 Connections

Describes connection methods for ESL repair in vehicle and on bench using different boxes.

6.2 ESL (ELV) diagrams;pinouts for connection on bench

Provides diagrams and pinouts for ESL connectors for bench connections.

6.3 Procedure Execution

Details the steps to execute the ESL repair procedure in the software.

7. DSM replacement

7.1 Direct Select Module (DSM) replacement procedure

Outlines the procedure for replacing DSM modules, including data saving and VIN programming.

7.2 Connections

Describes the necessary connections and adapters for DSM replacement.

7.3 Requirements

Lists the required hardware and software for DSM replacement.

8 More functionalities of the FBS4 Manger

8.1 ECU Recovery procedure

Explains the steps to recover an Engine Control Unit using the FBS4 Manager software.