EasyManua.ls Logo

Absaar AB-JS012 - Charger Safety Notices; Important Safety and Operating Instructions

Absaar AB-JS012
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
EN
OVER 40 YEARS OF GERMAN TECHNOLOGY
The manufacturer is not responsible for damages caused by:
* Improper connection and / or operation.
* Exterior force, damage to the device and / or damage to parts of the device caused by mechanical
impact or overload.
* Any type of modication to the device.
* Use of the device for purposes that are not described in this instruction manual.
* Consequential damages caused by non-intended and / or improper use, and / or defective batteries.
* Moisture and / or insufcient ventilation.
* The unauthorised opening of the device. This will viod the guarantee.
Safety notices for charger:
1. SAVE THESE INSTRUCTIONS - This manual contains important safety and operating instruc-
tions for battery charger.
2. Before using battery charger, read all instructions and cautionary markings on battery charger and
battery.
3. Non- rechargeable batteries cannot be charged with this battery charger.
4. During charging, the battery must be placed in a well ventilated area. Keep the working area tidy to
reduce the risk of re, electric shock and explosion. Do not cover the charger and battery pack with a
cloth while charging.
5. The battery charger contains components which can produce arcs and sparks when in use. WARNING:
Explosive gases. Prevent ames and sparks. Provide adequate ventilation during charging.
6. To prevent re or explosion, only use in a well-ventilated area. When charging, it is prohibited to start
the engine or perform ignition and other dangerous actions. Do not charge in a garage or other enclosed
space. Provide adequate ventilation during charging.
7. Never touch battery terminals or battery clamps whilst the device is connected to alternating current.
8. Use a power source with the voltage specied on the nameplate of the charger.
9. Check the input voltage (230V ~ 50Hz) and ensure that it corresponds to the mains voltage, otherwise
the charger may be damaged.
10. If an extension cable is used, the cable diameter must be sufcient for the power required by the
charger
11. Do not charge the battery packs in presence of ammable liquids or gases.
12. Never short circuit the device or connect the inlets and outlets of the device using metal objects.
Only use the supplied connecting cables to connect the device to a battery.
13. Always make sure that the charger is disconnected from the mains when you connect it and
disconnect it to a battery.
14. Never place the device over or close to the battery to be charged. Gases from the battery make the
charger corrode and damage it. Set up the charger as far away from the battery as the direct current
cable allows.
15. Ensure that the device is always stored in a safe place. Do not expose the device to rain or snow or
other wet conditions. Avoid pouring or dripping water or other liquids over it. If water penetrates electrical
devices, the risk of electric shock increases.
16. To protect against the risk of electrical shock, do not immerse the unit, cord or plug in water or other
liquid.
17. Ensure that all plugs and cables are free of moisture. Never connect the device to the mains with
wet or moist hands.
18. Never carry charger by cord or yank it to disconnect from receptacle.
19. After charging or before attempting any maintenance or cleaning, unplug the charger from the power

Related product manuals