Do you have a question about the Absima APC-1 and is the answer not in the manual?
Describes automatic and manual charging modes for Lithium batteries, including current limit settings.
Details the parameters and process for discharging Lithium batteries.
Explains the storage mode for Lithium batteries and how to set it.
Covers automatic and manual charging modes for NiMH/NiCd batteries.
Explains the process and parameters for discharging NiMH/NiCd batteries.
Details the charge/discharge cycling modes for NiMH/NiCd batteries.
Explains the digital power program for outputting DC voltage for other electronic equipment.
Guides on charging Pb batteries, including current and voltage settings.
Outlines the parameters and steps for discharging Pb batteries.
Details how to use the battery meter to check cell voltage and input/output.
Explains using the Battery IR Meter to check internal resistance for battery quality.
Indicates the output is connected to a battery with incorrect polarity.
Detects an interruption of the connection between battery and output.
Indicates a short-circuit at the output, requiring lead inspection.
Alerts when the input power voltage drops below the set limit.
Covers low/high voltage detection for the battery pack or individual cells.
Signals bad connections at the individual cell connectors.
Indicates the internal temperature of the unit is too high.
Lists essential warnings to prevent malfunction, fire, and injury.
Provides critical do's and don'ts for safe charging and handling.
Emphasizes ventilation, fire safety, and monitoring during charging.
Details the two-year warranty against manufacturing defects.
Lists conditions like misuse, improper installation, and wear not covered.
States compliance with EU directives and standards like EMC and RoHS.
Provides guidance for users in the EU on proper disposal of waste equipment.
| Input Voltage | 100-240V AC |
|---|---|
| Discharge Power | 5W |
| Charge Current | 0.1A |
| Battery Type | LiPo, LiFe, NiMH, NiCd, Pb |
| Discharge Current | 0.1A |