Page 7 of 34
The Extreme-Duty Flexible Mat is designed to quickly break down small clay clods and reset a
surface that is infrequently maintained or after light renovation work. This mat is 6' wide by 3'
long and is the most extreme duty drag mat on the market. The steel mesh is made of
extremely thick rust resistant galvanized steel. The rods are 6 Gauge wrie and the ends are
welded to protect the edges from fraying as it hits bases, fencing and other obstacles. The
drag bar is 1/8" thick angle iron to eliminate bending.
The Coco Mat is an ideal solution to get wet fields ready for games. This 6' wide and 2' long
mat incorporates a leveling bar and allows the coco matting to be replaced once worn.
Aerating, Fertilizing, & Seeding:
By adding additional optional attachments, the ABI Force quickly transforms into a zero-turn commercial-grade
seeding and fertilizing system, gravel and dirt-work scarifier rake, a plug aerator, and an overseeder. The ABI Force
is also equipped with a rear hitch for towing equipment, such as a cultipacker, dump trailer, or ABI Water Trailer.
The Hydraulic Seed & Fertilizer Spreader can hold 120lbs of material and has an
adjustable spread pattern from 4 to 25 feet, adjustable flow, and side deflector. This
commercial-grade and independently-controlled hydraulic spreader is ideal for
precisely broadcasting grass seed and fertilizer. Spread seed after plug aerating and
pull a seed-drill cultipacker behind to overseed. Spreader must be ordered at time
of original purchase for factory installation.
The 40" Plug Aerator is capable of working 80,000 square feet per hour and at 400
lbs. can produce core depths up to 3 1/2". With this option, the ABI Force is an
efficient and maneuverable zero-turn plug aerator, with manual weight to ensure
consistent penetration! Pull an XD drag mat or cultipacker behind to breakup
aeration cores in the same pass! Plug Aerator may be added after original purchase.
The 48" Seed-drill Cultipacker weighs 272 lbs. and presses fresh-spread seed into
the soil for superior germination. The packer wheels are 9.5" around with a solid 1
3/4" steel packer wheel shaft and agricultural-grade greaseable pillow block
bearings. These units are also equipped with two pneumatic tires for easy flip-over
transport.
The Hydraulic Scarifier Rake is designed for aggressive gravel and dirt work from
removing potholes in parking lots to preparing the perfect seedbed. These
hydraulically adjustable scarifiers and multi-function rake have the teeth for tough
work. For a start to finish seeding solution, add the ripper teeth, the hydraulic seed
spreader, and the rear seed-drill cultipacker. Easily seed tight areas near buildings,
around irrigation heads, trees, landscape beds, between sidewalks, along curbs,
and fences.
To Next Page
Loading...