EasyManua.ls Logo

Abus Bordo 6500A - Initial Setup and Charging; Charging Socket Care

Abus Bordo 6500A
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26 27
- A damaged battery could irritate your
airways, skin and eyes. In the event of
contact, immediately rinse the
aected area with water and seek
medical attention. The liquid inside
the battery is ammable!
- The battery may only be charged if the
lock body housing is not damaged. If
there is visible damage on the lock
body such as cracks or holes, the
battery must not be charged!
- Do not use or store the product in
areas where the temperature could
reach below -20°C or above +40°C. Do
not expose the product to direct
sunlight for long periods of time!
- Never attempt to open the product
and remove the battery. This could
lead to damage (battery outgassing,
short circuit, etc.).
- Do not use a high-pressure cleaner
(IP class 44) or aggressive cleaning
agents to clean the lock.
- Check the lock for damage at least
once a year. If there is visible damage
on the lock body such as cracks or
holes, the lock must no longer be
used.
- The product may only be used for its
When delivered, the lock is in transport
mode (The bar is only latched in the lock,
not locked).
In order to use the lock, the battery must
rst be fully charged.
While charging the device, install the
Smart X app (→ chapter 2, page 30).
1.
First commissioning and charging
the battery
Attention
1.1
Alwayslithecapbyhand
without the use of tools, to
avoid damaging the charging
socket.
Attention
intended purpose. Any modication to
the product is prohibited.

Related product manuals