What to do if Abus COWM510 Gas Detectors signals low battery?
If your Abus Gas Detector signals low battery performance, replace the batteries immediately, but no later than within 7 days. Ensure you use only 1.5 V brand alkaline AA batteries of the same type.
What to do when Abus Gas Detectors indicates end of sensor lifespan?
If your Abus Gas Detector indicates the end of the sensor lifespan, you must replace the entire alarm immediately.
What to do if Abus COWM510 registers a sensor error?
If your Abus Gas Detector registers a sensor error, the entire alarm must be replaced. The sensor itself cannot be replaced.
How to fix Abus Gas Detectors that does not react after a functional test?
If the Abus Gas Detector does not react after a functional test, check that the batteries are inserted correctly, paying attention to the polarity.
General| Product Type | Carbon Monoxide Detector |
|---|---|
| Sensor Technology | Electrochemical |
| Alarm Volume | 85 dB |
| Power Source | Battery |
| Certifications | EN 50291 |
| Model | COWM510 |
| Brand | Abus |
| Detected Gas | Carbon Monoxide (CO) |
| Weight | 150 g |
| Humidity | Up to 90% RH non-condensing |
| Alarm Levels | 50 ppm, 100 ppm, 300 ppm |
To Next Page
