5 6
4. Adjustment of the straps
Make sure the chin-guard, which must be locked before every ride, doesn’t lie on the
5. Proper maintenance and care
• Regularly check the helmet for signs of damage.
• Do not apply stickers or paint to the helmet as this can be damaging to the materials.
• Do not remodel or misuse the helmet.
• If you suspect that the helmet has received a large impact, even if there is no visible
damage, please purchase a new helmet.
• This helmet has a limited service life and should be replaced when it shows obvious
signs of wear.
-
production date even if it displays no clear visible or technical defects
• The helmet, inner pads and head ring can be cleaned using lukewarm water,
• Only use original spare parts.
• Please contact your local waste disposal company for correct disposal.
• No particular packaging is recommended for the transport of the PPE, in case use the
original package/box.
Congratulations! You are now the owner of a top quality ABUS bicycle helmet. This
following standards:
• EN 1078:2012+A1:2012 – European standard for pedal cyclists and for users of skateboards
and roller skaters
• The helmet is a PPE of category II according to the Directive 89/686 and it has been
certified by ITALCERT S.r.l. (Notified Body n° 0426), Viale Sarca 336, I-20126 Milano.
• The helmet complies with the requirements of the standrad EN 1078:2012+A1:2012 used
for the design of the PPE and for the certification procedure.
• The full declaration of conformity can be found at https://docs.abus.com/
Attention: Please note that no helmet is indestructible and will not prevent all head injuries.
For the best possible protection, please observe the following guidelines:
1. Usage
Attention: Please note that it is necessary for children to remove their helmets before
entering playgrounds. This helmet should not be used by children while climbing or
doing other activities when there is a risk of strangulation/hanging if the child gets
trapped with the helmet.
2. Optimum fit
• Please try various sizes for comfort and security, ensuring that the helmet sits
horizontally on your head.
• Do not pull the helmet over your forehead, reducing visibility.
• Do not push the helmet towards the back of your head, as this will not protect
your forehead.
3. Adjustement of the head ring
Almost all ABUS helmets are available in 2 sizes.
Adjusting the helmet to the individual head size
can be achieved, depending on the type, with the
EN 1078:2012+A1:2012
To Next Page
Loading...
Need help?
General
Weight and Dimensions
