103
7.9 Schedules
Here up to 10 different schedules can be configured for later use in the Event Manager.
The “Add” button is used to open the input mask for the configuration of the schedule.
7.10 Detectors
7.10.1 Motion detection
Enable motion detection: enables motion detection.
Enable dynamic analysis for motion: if enabled, changes to the video image content are
displayed graphically in the preview.
NOTE: The LIVE INDICATOR function decides whether this should also be displayed in the
live image.
Preview area: preview and configuration area.
Draw Area: draw areas here (max. 8), which should be monitored by motion
detection. Operation: Press button -> draw rectangle in the preview
using left mouse button -> press button again to finish drawing.
Delete: delete all areas.
Mode: Switch between Normal and Expert mode
Normal: basic sensitivity settings
Expert: sensitivity and object size (“percentage”) can be configured, a
profile can be applied per schedule, 8 areas
Day/night switching: defines how motion detection is applied during the day or night mode.
Off: settings for day and night are identical.
Automatic switching: settings are automatically coupled to automatic
day/night switching.
Schedule: settings for day and night are applied according to a
schedule.
Sensitivity: determines the required intensity of the pixel change. The higher
the value, the fewer pixel changes are required to trigger motion.
Percentage: [only in expert mode] object size required for triggering motion in
the area (0–100%).
To Next Page
Loading...
Need help?
General
