Abus TVAC14010A - Safety and Operation; Explanation of Symbols; Important Safety Guidelines; Operational Safety Instructions

17
English
Explanation of symbols
The triangular high voltage symbol is used to warn of the risk of
injury or health hazards (e.g. caused by electric shock).
The triangular warning symbol indicates important notes in this user manual which
must be observed.
This symbol indicates special tips and notes on the operation of the unit.
Important safety information
All guarantee claims are invalid in the event of damage caused by non-compliance with
this user manual. We cannot be held liable for resulting damage.
In the event of material or personal damage caused by improper operation or non-
compliance with the safety information, we cannot be held liable. All guarantee claims
are void in such cases.
This device has been manufactured in accordance with international safety standards.
Please read the following safety instructions carefully.
Safety information
1. Power supply
Only operate the camera through a power source which supplies the mains power specified on
the type plate. If you are unsure of the installation location's power supply, contact your power
supply company. Disconnect the device from the power supply before carrying out
maintenance or installation work.
2. Overloading
Avoid overloading electrical sockets, extension cables, and adapters, as this can result in fires
or electric shocks.
3. Cleaning
Only use a damp cloth to clean the camera. Do not use corrosive cleaning materials.
Disconnect the monitor and camera from the power supply before cleaning.
4. Accessories
Only connect accessories that are expressly suitable for their intended purpose. Otherwise,
hazardous situations or damage to the monitor or camera may occur.
5. Installation location
The camera is suitable both for operation in protected outdoor areas as well as indoors. The
product may be damaged if it is dropped, even from a low height. Install the camera so that
the image sensor is not exposed to direct sunlight. Pay attention to the installation instructions
in the corresponding section of this user manual. Only operate the camera at locations where
temperatures within the permitted ambient temperature range prevail.
Camera -10°~ +50°C
6. Wireless transmission
The wireless transmission range depends on a variety of environmental factors. The local
conditions at the installation location may have a negative impact on the range. When there
are no obstructions between the receiver and transmitter, a range of up to 150 m is possible,
but this range will be considerably smaller within buildings.
The following environmental conditions compromise both the range and frame rate:
mobile communication masts, high-tension pylons, electrical wires, ceilings and walls, devices
with an identical or adjacent wireless frequency.