37
CYCLE MODE (ON & OFF)
Set an on duration and an off duration for the fan to
cycle through continuously. Press the up or down
button to first set a duration for the fan to activate.
Then press the mode button again and set a dura-
tion for the fan to deactivate.
When the fan is activated, it will run at the speed set
in ON Mode. When the fan is deactivated, it will run
at the speed set in OFF Mode.
The countdown will begin if no buttons are pressed
for 5 seconds. The time left on the countdown is
shown on the bottom left corner of the display.
Leaving the cycle mode while the countdown is
running will pause it until you return to this mode.
If there is a speed set in OFF Mode
other than zero, the fans will run at
that speed when triggered to turn off.
PROGRAMMING
To Next Page
Loading...
