39
°F/°C SETTING
Changes the displayed units to Fahrenheit or Celsius.
Press the up or down button to cycle through F and
C. All displayed units will automatically convert when
adjusting this setting.
CALIBRATION TEMPERATURE SETTING
Adjusts the temperature reading the sensor probe is
measuring. Press the up or down button to increase or
decrease the data figure in 2°F (or 1°C) increments.
The calibration cycle ranges from -20°F to 20°F (or
-10°C to 10°C) and will be applied to the sensor probe’s
measurements.
PROGRAMMING
To Next Page
Loading...
