Need help?Do you have a question about the ACA Citabria Explorer 7ECA and is the answer not in the manual?
General operating limitations and adherence to placards and instrument markings.
Approved categories and conditions for flight operations.
Specifications for engine, horsepower, and fuel types.
Designations and limits for various airspeeds like VNE and VA.
Maximum weight and center of gravity ranges for different models.
Maximum positive and negative load factors for normal and acrobatic categories.
List of aerobatic maneuvers and their required entrance speeds.
List of essential placards and their locations within the aircraft.
Pilot responsibility for judgement and familiarity with procedures.
Recommended actions for engine fires during start and in flight.
Actions for alternator failure and electrical fires.
Procedures for engine failure on takeoff and air restart attempts.
Actions for partial power loss or rough engine running.
Troubleshooting abnormal oil pressure or temperature readings.
Procedures for precautionary and forced landings.
Specific steps for making a forced landing on water.
Handling severe turbulence, stalls, and spins.
Actions after exceeding airspeed or load factor limits.
Procedures for emergency exit and parachute deployment.
Overview of normal operating procedures and checklist usage.
Detailed checklist for pre-flight aircraft inspection.
Pre-start checks including seat belts, brakes, and switches.
Procedures for starting a cold or hot engine.
Procedures for taxiing, especially in windy conditions.
Pre-takeoff checks and engine run-up procedures.
Steps for a normal takeoff, including speeds and attitude.
Procedures for taking off when obstacles are present.
Procedures for taking off from soft field conditions.
Recommended airspeeds and mixture settings for climbing.
Procedures for leveling off and maintaining cruise airspeed and power.
Information and safety considerations for aerobatic flight.
Procedures for descending, maintaining engine temperatures.
Steps for a normal landing approach and touchdown.
Procedures for landing when obstacles are present.
Steps for safely shutting down the aircraft engine and securing it.
Purpose of flight performance data and pilot's logbook importance.
Table showing indicated vs. calibrated airspeed conversions.
Table detailing stall speeds with and without flaps.
Data on takeoff distance and rate of climb based on altitude/temp.
Data for best rate of climb based on altitude/temperature.
Specifications for cruise speed at 75% horsepower.
Summary table of key performance parameters like top speed and range.
Pilot's responsibility for proper loading and limitations.
Steps to determine aircraft weight and moment.
Example calculation for determining weight and balance.
Graphical representation of weight and moment limits for balance requirements.
Overview of aircraft systems and optional equipment.
Required aircraft documents and their locations.
Description of the aircraft's construction and materials.
Details on the engine type, ignition, and starting procedures.
Description of dual controls, trim, and their mechanisms.
Operation and settings for the 7GCBC model flaps.
Description of landing gear, tail wheel, and hydraulic brakes.
Details on the 12-volt DC electrical system and components.
Description of fuel tanks, shutoff valve, and gascolator.
How cabin heat and fresh air systems operate.
Information on interior and exterior lighting systems.
Description of various flight instruments and their operation.
Overview of communication and navigation equipment.
Description of doors, windows, seats, and baggage area.
Details on special corrosion proofing for protection.
Information on the seaplane kit and its features.
Equipment and procedure for glider/banner towing.
Overview of ground handling, servicing, cleaning, and storage.
Specifications for fuel, oil, brakes, tires, and lubrication.
Procedures for maneuvering the aircraft on the ground.
Methods for safely jacking the aircraft.
Procedures for securing the aircraft in high winds.
Access points for engine and system servicing.
Fueling precautions and system checks.
Battery location, maintenance, and removal procedures.
Brake fluid reservoir and replenishment.
Tire condition checks and inflation pressures.
Engine oil level checks and oil change intervals.
Inspection and cleaning of the engine air filter.
Procedures for cleaning the aircraft's exterior surfaces.
Procedures for cleaning the aircraft's windshield.
Procedure for cleaning the engine.
Procedure for cleaning the aircraft interior.
Guidelines for storing the aircraft during non-operational periods.
To Next Page
General