Need help?Do you have a question about the ACA Citabria Explorer 7GCAA and is the answer not in the manual?
General| Manufacturer | American Champion Aircraft |
|---|---|
| Model | Citabria Explorer 7GCAA |
| Seats | 2 |
| Engine | Lycoming O-320-A2B |
| Horsepower | 150 hp |
| Rate of Climb | 800 ft/min |
| Range | 450 miles |
| Category | Aircraft |
| Wingspan | 33.5 ft (10.2 m) |
This section lists all power plant and airframe operating limitations.
Details approved categories and conditions for Citabria flight operations.
Specifies limitations for the aircraft's engine and power plant.
Defines critical airspeed restrictions and ranges for safe operation.
Outlines the acceptable weight and center of gravity ranges for aircraft.
Specifies maximum positive and negative G-force limits for flight.
Lists approved aerobatic maneuvers and their entrance speeds.
Details essential placards that must be visible to the pilot.
Procedures for handling emergency and adverse flight conditions.
Procedures for dealing with engine or electrical fires during flight.
Steps to take if a fire occurs while starting the engine.
Actions to take if an engine fire occurs during flight.
Procedures for managing an electrical fire.
Steps to take in case of alternator or electrical system failure.
Procedures for addressing engine malfunctions.
Actions to take if the engine fails during takeoff.
Steps to attempt an engine restart after a failure.
Procedures for handling engine power loss or rough running.
Steps for dealing with abnormal oil pressure or temperature readings.
General guidance for emergency landing situations.
Procedure for making a precautionary landing when power is available.
Steps for a forced landing due to complete engine failure.
Procedures for making a forced landing on water.
Guidance for handling abnormal flight situations.
Recommended actions to take in severe turbulence.
Procedures for recovering from a stall.
Steps to take if an inadvertent spin occurs.
Actions to take if the aircraft experiences overstress.
Procedures for exiting the aircraft in an emergency.
Overview of normal operating procedures using a checklist format.
Detailed checklist for inspecting the aircraft before flight.
Steps to perform before starting the engine.
Procedures for starting a cold or hot engine.
Procedures for taxiing the aircraft.
Pre-takeoff checks and procedures.
Standard procedure for taking off.
Procedures for taking off with an obstacle.
Procedures for taking off from a soft field.
Procedures for climbing the aircraft after takeoff.
Procedures for maintaining cruise flight.
Information and precautions for performing aerobatic maneuvers.
Procedures for descending the aircraft.
Standard procedures for landing the aircraft.
Procedures for landing with an obstacle.
Procedures for shutting down the engine and aircraft.
Information on expected aircraft performance and pre-flight planning.
Table relating indicated airspeed to calibrated airspeed.
Table listing stall speeds with and without flaps.
Data on takeoff distance and rate of climb vs. altitude/temp.
Table showing climb performance for different models.
Table detailing cruise speed and fuel consumption.
Pilot's responsibility for proper loading and weight/balance limitations.
Steps to determine aircraft weight and moment.
Example calculation for loading the aircraft.
Diagrams showing acceptable weight and moment ranges for safe flight.
Overview of aircraft and systems, including model specifications.
Required aircraft documents and their locations.
Details on the aircraft's construction and materials.
Description of the aircraft's Lycoming engine and its systems.
Explanation of the aircraft's control surfaces and mechanisms.
Description of the flap system specific to the 7GCBC model.
Details on the landing gear and hydraulic brake system.
Explanation of the aircraft's 12-volt electrical system and components.
Description of the fuel system, tanks, and controls.
Details on the aircraft's heating and fresh air systems.
Information on exterior and interior lighting systems.
Description of the aircraft's primary flight instruments.
Information on the aircraft's communication and navigation equipment.
Description of cabin amenities and safety features.
Overview of optional features and modifications.
Details on corrosion protection measures.
Information regarding the seaplane certification and kit.
Description of the equipment for glider or banner towing.
Overview of ground handling, servicing, cleaning, and storage procedures.
Table of fuel, oil, brake, tire, and lubrication specifications.
Procedures for safely maneuvering the aircraft on the ground.
Instructions on how to properly jack the aircraft.
Procedures for securing the aircraft in high winds.
Information on accessing components for maintenance.
Servicing procedures for the fuel system.
Maintenance and servicing of the aircraft battery.
Servicing procedures for the brake system.
Inspection and maintenance of aircraft tires.
Procedures for checking and changing engine oil.
Inspection and cleaning of the engine air filter.
General cleaning procedures for the aircraft.
Cleaning and waxing the aircraft's exterior.
Cleaning and care of the aircraft windshield.
Procedures for cleaning the engine.
Cleaning procedures for the aircraft interior.
Procedures for storing the aircraft during non-operational periods.
To Next Page