1. Open shutter panels and position the light block on the window sill. The front of the light block
should be flush with the front of the left and right frames. Make sure magnets on panels will latch
onto the magnet catches on the light block.
Install the plugs into the frames’ pre-drilled plug holes to
complete the look of your shutters.
Shutter Installation Instructions
Z Frame Inside Mount 2 Sides Cafe Shutters
Installation Video
Scan the QR code with
your smartphone to
follow along with video
instructions.
CONGRATULATIONS
on purchasing the finest shutters in the market.
You can take pride that your purchase will enhance the function and beauty of your home.
IMPORTANT: Do not mix panels or frames from other windows. Install one shutter at a time.
Getting Started
Remove the shutter from the package. Do not discard any of the packaging material until the
shutter operates to your satisfaction. Check the diagram below to make sure you have the
necessary parts.
Version 37103-65200
Step 3: Secure the Light Block
Step 4: Install the Plugs
Once aligned properly, secure the light block with the light block screws provided through each
pre-drilled hole.
2.
Light Block
Step 1: Assemble Frame
Getting Started
Step 2: Attach the Panels
Step 3: Secure the Light Block
Step 4: Install the Plugs
INSTALLATION OVERVIEW
Light Block
Z Frame
Z Frame Inside Mount 2 Sides Cafe Shutter
Shutter
Panel
Hinge
Pins
Hinge
Pins
Tension
Adjuster
+
+
Customer Service
Phone: 855.667.6261
Email: Blinds.comSupport@NormanUSA.com
Adjust the Tension System
If over a period of time the louvers on your shutters should loosen or not
function properly, a built-in tension system can be adjusted. Simply open the
panels fully and find the tension adjuster screw hole on the side of each panel.
Use a screwdriver to gently turn the screw on each side of the panel to your
desired resistance level. Repeat process for other panel(s) if necessary.
Lifetime Limited Warranty
All Acadia Living shutters have a lifetime limited warranty and will be free from defects in materials or
workmanship for as long as the original retail purchaser owns the shutters, provided that such products
were properly installed in residential dwelling; and such products were made or assembled exclusively
from original materials and components. Any resale or other transfer of the product and/or materials
voids this warranty.
For a complete copy of this warranty, please contact customer service by phone or email.
Maintain Your Shutters
Use a clean dry cloth, feather duster or vacuum with brush attachment to gently remove dust and debris.
To ensure thorough cleaning, wipe the louvers in the open and closed positions.
Do not immerse the product in water and do not use harsh chemicals to clean. This may cause
discoloration and the wood to warp. Ultrasonic cleaning is not recommended. For best results on
Composite Shutters, use a cotton cloth dampened with water. Polyester cloths tend to create static,
which can attract dust.
L Bracket (30mm)
for T-post without top/bottom
frame (if applicable)
Hinge Screws
Screws for L bracket
(30mm) (if applicable)
Hinge Pins
Frame Screws
Hinge Spacers
Light Block Screws
Screws for L bracket
(30mm) (if applicable)
Plug
63.5mm [2 1/2"]
38mm [1 1/2"]
18.5mm [3/4"]
Hinge Screws for
1" T-post with panel
folds include RTL
(if applicable)
11mm [7/16"]
To Next Page
Need help?
General