Access Flow2A - Maintenance; Maintenance Timer

Maintenance
19
5.4 Maintenance timer
The stairlift is equipped with a maintenance timer to guarantee optimum safety. After approximately 20
months (or sooner if used more than average), the maintenance timer will operate.
If you give a command using one of the controls, the status indicator will flash red (with fast intermittent
beeps). The stairlift will start moving with a 1-second delay.
1. Remove the joystick from the armrest control unit.
2. Wait for at least 1 second.
3. Insert the joystick back into the armrest control unit.
CAUTION
If you do not do these steps after approximately 24 months of average use, a
continuous beep will sound and the status indicator of the used control will flash
red. You can finish the ride with the stairlift. The stairlift will stop at a safe place.
1. Remove the joystick from the armrest control unit.
2. Wait for at least 1 second.
3. Insert the joystick back into the armrest control unit.