Access Stair-Glide Excel - Table of Contents

This serial number contains important information
about your lift. This number may be needed if the
lift requires replacement parts. Please keep it handy.
Contents
Introduction..................................................................... 3
Operation and Description of Features........................4-5
Keeping your Lift Trouble Free ....................................5-6
Maintenance................................................................... 6
Troubleshooting ............................................................. 7
Limited Warranty ............................................................ 8
xxIM0203-407
IMPORTANT
The serial number of your
Stair-Glide
®
Excel
®
Stairway Lift is:
General Specifications
Application:
Maximum Travel:
Lifting Capacity:
Rated Speed:
Power Supply:
Motor:
Drive System:
Track:
Angle of Incline:
Indoor, straight run stairways
32 feet
300 pounds (136kg)
25 feet per minute
115 VAC, 60 Hz, 3-wire grounded outlet
(NEC requires that this outlet be dedicated)
1/2 hp, 24 VDC (battery operated)
or 1/2 hp, 120 VDC (AC operated)
Rack and pinion
Extruded aluminum, clear anodized
25° to 45°
It is important that this entire manual be read and
understood prior to attempting operation of equipment.
Also, please observe all cautions and warnings!
7
Troubleshooting
Before you call for service. . . . . .
A quick check of the Operating Instructions in this manual may prevent an
unnecessary service call. Before calling your authorized Access
Industries' dealer for service, refer to the following checklist . . .
If lift will not operate:
 Check for obstructions in the path of the lift.
 Check that the swivel seat is in the locked, riding position.
 Replace the 9V batteries in the wireless remote controls if necessary.
(make sure the + and - are installed correctly)
If lift will still not operate, contact your local authorized dealer for immediate
service. If your lift needs servicing, use only original replacement parts
and hardware to maintain quality and performance.
Information on Battery Operated Lifts Only:
If the Lift Bleeps After Stopping:
When the lift stops and the 115 VAC power is not connected, the bleeper
will sound for 20 seconds and stop, the control board will then go into
standby mode. Make sure the lift's power cord is plugged into the 115
VAC outlet or check for a blown fuse or tripped circuit breaker at the main
circuit box.
If the Lift Bleeps While Running:
Battery capacity is 30% or less. This may have been caused by:
1) Batteries have not been charged.
2) Heavy use of the lift.
3) The batteries are not holding their charge due to age.
Contact your authorized dealer for service.
If the Lift Runs at Half Speed
Battery capacity is 10% or less. This may have been caused by the
reasons above.
Contact your authorized dealer for service.