160 CHAPTER 16
Parameter of the effects menu
FEEDBACK Controls the amount of
feedback in the Phaser. On the
phaser, FEEDBACK lets you boost
specific frequencies in the phase-
shifted signal. The FEEDBACK
parameter is bipolar; positive or
negative feedback values let you
dial in different phaser characteris-
tics.
01111111111111111112
1 PHASER
Feedback +0≤
61111111111111111154
STAGES Use STAGES (1-6) to select
the number of phaser stages or fil-
ter poles. This determines directly
the number of filter notches and
peaks in the phaser signal.
01111111111111111112
1 PHASER
Stages 4≤
61111111111111111154
SPREAD Use SPREAD to increase or
decrease the distance between the
notches and peaks in the fre-
quency spectrum. In other words,
here you can adjust bandwidth of
the phaser effect.
01111111111111111112
1 PHASER
Spread 127≤
61111111111111111154
To Next Page
Loading...
