To Next PageTo Next PageWhat to do if blood glucose result has not been sent to the paired device on ACCU-CHECK?
If your ACCU-CHECK Blood Glucose Meter displays that the blood glucose result has not been sent to the default paired device and the transfer is still pending, place the meter and paired device closer together.
What to do if ACCU-CHECK Blood Glucose Meter says batteries are out of power?
If your ACCU-CHECK Blood Glucose Meter displays a message indicating that the batteries are out of power, replace them immediately. If the message persists after replacing the batteries, slide the battery drawer out, press any button on the meter, and then reinsert the drawer.
What to do if the connection between ACCU-CHECK AVIVA CONNECT and PC was lost?
If you encounter a lost connection between your ACCU-CHECK Blood Glucose Meter and your PC, disconnect and then reconnect the USB cable, and try the connection again.
Why can't I perform a test when ACCU-CHECK Blood Glucose Meter is connected to a PC?
If your ACCU-CHECK Blood Glucose Meter is connected to a PC, you cannot perform a test. Either remove the USB cable and perform a test, or remove the test strip and start a data transfer.
What to do if ACCU-CHECK AVIVA CONNECT Blood Glucose Meter was unable to pair with a device?
If the ACCU-CHECK Blood Glucose Meter does not pair with a device, retry the pairing.
How to establish a connection between ACCU-CHECK AVIVA CONNECT Blood Glucose Meter and PC?
If there is no connection between your ACCU-CHECK Blood Glucose Meter and your PC, connect the USB cable and retry the connection.
What to do if ACCU-CHECK Blood Glucose Meter shows temperature error?
If your ACCU-CHECK Blood Glucose Meter displays that the temperature is above or below the proper range for the system, refer to the test strip package insert for system operating conditions. Move to an area with the appropriate conditions, wait 5 minutes, and repeat the blood glucose or control test. Do not artificially heat or cool the meter.
What to do if not enough blood was drawn into the ACCU-CHECK AVIVA CONNECT test strip?
If the ACCU-CHECK Blood Glucose Meter displays a message indicating that not enough blood or control solution was drawn into the test strip for measurement, or was applied after the test had started, discard the test strip and repeat the blood glucose or control test.
Why can't I pair my ACCU-CHECK device while in Flight Mode?
If your ACCU-CHECK Blood Glucose Meter displays that pairing to a device cannot be performed while in Flight Mode, retry pairing when the meter is not in Flight Mode.
Why can't I send data to a paired device when ACCU-CHECK Blood Glucose Meter is in Flight Mode?
If your ACCU-CHECK Blood Glucose Meter displays that data cannot be sent to a paired device because the meter is in Flight Mode, retry the data transfer when the meter is not in Flight Mode.
Describes the front, back, and side views of the Accu-Chek Aviva Connect meter.
Explains the functions of the Back, Up/Down Arrow, and Power/Set/OK buttons.
Illustrates the meter's menu structure and navigation using arrow buttons.
Lists and describes various icons displayed on the meter screen.
Guides the user on how to select the meter's display language.
Outlines the situations when a control test should be performed.
Details usage, handling, and expiration for control solutions.
Step-by-step instructions for performing a control test with the meter.
Provides essential guidelines for using the Accu-Chek Aviva Connect system.
Detailed procedure for performing blood glucose tests using fingertip samples.
Describes symptoms associated with low and high blood glucose levels.
Lists adjustable settings like Time/Date, Beeper, USB Default, and Target Range.
Instructions on setting the correct time and date on the meter.
Explains the beeper prompts and how to turn it on or off.
Configures the meter's behavior when connected to a PC via USB.
Guides on setting and customizing blood glucose target ranges.
Option to display the previous blood glucose result alongside the current one.
Allows selection of the display language for the meter.
Details how to access and scroll through recorded blood glucose test results.
Explains how to view average blood glucose values over different time periods.
Instructions for transferring data to a PC or generating PC reports.
Introduces wireless synchronization with mobile devices and online accounts.
Provides steps for initial wireless pairing and device setup.
Step-by-step guide to pair the meter with a mobile device.
Explains how to enable or disable flight mode and its effect on wireless communication.
Allows selection of the primary device for auto-send and sync time features.
Manages automatic data transfer to the default paired device after each test.
Enables synchronization of meter time and date with the default paired device.
Instructions for removing previously paired devices from the meter.
Explains the two options for viewing data on a PC: Data Transfer and PC Reports.
Configures the meter to default to Data Transfer for PC connectivity.
Configures the meter to default to PC Reports for PC connectivity.
Guides on transferring data to specialized diabetes management software.
Instructs on viewing data reports via an internet browser.
Explains the Trend Report, showing blood glucose trends over time.
Details the Standard Day Report, illustrating daily blood glucose patterns.
Explains the Standard Week Report, showing weekly blood glucose patterns.
Describes the List Report, presenting test results sorted by date and time.
Step-by-step guide for replacing the meter's batteries.
Procedures for cleaning and disinfecting the blood glucose meter.
Comprehensive list and explanations of meter error messages and their solutions.
Provides information on product specifications and limitations.
Covers compliance and technical aspects of the meter's Bluetooth functionality.
Guidance on the proper and safe disposal of the meter.
Defines various symbols found on the meter and its packaging.
Explains the low/high blood glucose indexes and their risk assessments.
General| Brand | Accu-Chek |
|---|---|
| Model | Aviva Connect |
| Category | Blood Glucose Meter |
| Display | LCD |
| Test Time | 5 seconds |
| Sample Size | 0.6 µL |
| Connectivity | Bluetooth |
| Battery Life | Approximately 1000 tests |
| Calibration | Plasma |
| Battery Type | CR2032 |
| Operating Temperature | 6°C to 44°C |
| Operating Humidity | 10 to 90% RH |
| Compatible Strips | ACCU-CHECK AVIVA test strips |
| Measuring Range | 10 to 600 mg/dL |
