EasyManua.ls Logo

Accu-Lites PM42 User Manual

Default Icon
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
118
S.
Main
St
***Suite 9
-Wauconda,
IL
60084 - 847-224-7914
PM42 Breakout Board Installation Instructions
The breakout board eliminates soldering connections to the card edge or card edge
adapter
of
a PM42 circuit breaker/reverser board.
Making Connections:
Strip approximately .125" (1/8 inch) off your wire. Either solid or stranded wire can
be used, from 12 AWG to 26 AWG. Insert the bare portion
of
the wire into the terminal
block and tighten the screw to make a solid connection.
Do not over-tighten, as the terminal blocks can be stripped or broken with too
much force.
The instructions
on
the next page describe the board and connections as if the large
connector for the PM42 is at the top; matching the orientation
of
the picture above.
Question and Answer IconNeed help?

Do you have a question about the Accu-Lites PM42 and is the answer not in the manual?

Accu-Lites PM42 Specifications

General IconGeneral
BrandAccu-Lites
ModelPM42
CategoryController
LanguageEnglish

Summary

PM42 Breakout Board Installation Guide

Secure Wire Connections

Explains wire stripping, gauge, and terminal block connection for secure wiring.

Connecting Power Inputs

Details connecting inputs from command stations/boosters, supporting up to two boosters.

Connecting Track Outputs

Describes connecting track outputs, identifying Rail A, and using output jumpers for reversing sections.

Power and Ground Setup

Explains connecting the 12V-18V AC/DC power and common ground for system reference.