1111
5. Installation5. Installation
5.1 Unpacking and 5.1 Unpacking and InspectionInspection
1) Unpack the packaging and check the package contents. The1) Unpack the packaging and check the package contents. The
shipping package contains:shipping package contains:
●● A UPSA UPS
●● A user manualA user manual
●● A communication cableA communication cable
●● A battery cable (for TN2-6000S/TN2-10000S only)A battery cable (for TN2-6000S/TN2-10000S only)
2) Inspect the appearance of the UPS to see if there is any damage2) Inspect the appearance of the UPS to see if there is any damage
during transportation. Do not turn on the unit and notify the carrierduring transportation. Do not turn on the unit and notify the carrier
and dealer immediately if there is any damage or lacking of someand dealer immediately if there is any damage or lacking of some
parts.parts.
5.2 Input and output power cords and protective earth5.2 Input and output power cords and protective earth
ground installationground installation
1. Notes for installation1. Notes for installation
1) 1) The UThe UPS must PS must be installed be installed in a in a location with location with good good ventilation,ventilation,
far away from water, inflammable gas and corrosive agents.far away from water, inflammable gas and corrosive agents.
2) 2) Ensure the Ensure the air vents air vents on the on the front and front and rear of rear of the UPS the UPS are notare not
blocked. Allow at least 0.5m of space on each side.blocked. Allow at least 0.5m of space on each side.
3) 3) Condensation to Condensation to water dropwater drops s may occur may occur if the if the UPS is UPS is unpackedunpacked
in a very low temperature environment. In this case it isin a very low temperature environment. In this case it is
necessary to wait until the UPS is fully dried inside out beforenecessary to wait until the UPS is fully dried inside out before
proceeding installation and use. Otherwise there are hazards ofproceeding installation and use. Otherwise there are hazards of
electric shock.electric shock.
The system may be installed and wired only by qualifiedThe system may be installed and wired only by qualified
electricians in accordance with applicable safety regulations!electricians in accordance with applicable safety regulations!
To Next Page
Loading...