1010
Indicates the UPS output is short and the UPS wouldIndicates the UPS output is short and the UPS would
shut downshut down
Indicates the load is over the SPEC rangeIndicates the load is over the SPEC range
Battery InformationBattery Information
Indicates the battery voltage value, which could beIndicates the battery voltage value, which could be
displayed from 0 to 999Vdcdisplayed from 0 to 999Vdc
Indicates the battery capacitance percent, which couldIndicates the battery capacitance percent, which could
be displayed from 0 to 199%be displayed from 0 to 199%
Indicates the battery is over charged, and the UPSIndicates the battery is over charged, and the UPS
would be switched to Battery modewould be switched to Battery mode
Indicates the battery is weak, and the UPS would shutIndicates the battery is weak, and the UPS would shut
down soondown soon
Mode/Fault/Warning code InformationMode/Fault/Warning code Information
Indicates the operating mode of the UPS,Indicates the operating mode of the UPS,
Mode/Fault/Warning code or parallel quantity could beMode/Fault/Warning code or parallel quantity could be
displayed, and the codes are illuminated in detail in thedisplayed, and the codes are illuminated in detail in the
following chapterfollowing chapter
Inverter operating Inverter operating InformationInformation
Indicates the circuit of the inverter is workingIndicates the circuit of the inverter is working
Bypass operating InformationBypass operating Information
Indicates the circuit of Bypass is workingIndicates the circuit of Bypass is working
Output voltage and frequency and Bypass disable/enable selectionOutput voltage and frequency and Bypass disable/enable selection
InformationInformation
The four value of the output voltage could be selectedThe four value of the output voltage could be selected
when the UPS is in Standby or Bypass mode, and onlywhen the UPS is in Standby or Bypass mode, and only
one of them could be actived in the same timeone of them could be actived in the same time
The two frequency value of the output voltage could beThe two frequency value of the output voltage could be
selected when the UPS is in Standby or Bypass mode,selected when the UPS is in Standby or Bypass mode,
and only one of them could be actived in the same timeand only one of them could be actived in the same time
Bypass disable or enable could be selected when theBypass disable or enable could be selected when the
UPS is in Standby or Bypass mode, and only one ofUPS is in Standby or Bypass mode, and only one of
them could be actived in the same timethem could be actived in the same time
To Next Page
Loading...