3131
The UPS does not have the backup function when it is in Bypass mode.The UPS does not have the backup function when it is in Bypass mode.
The power used by the load is supplied from the utility power via internalThe power used by the load is supplied from the utility power via internal
filter.filter.
10.3 Line mode10.3 Line mode
The LCD display in Line mode is shown in the following diagram. TheThe LCD display in Line mode is shown in the following diagram. The
information about the utility power, the battery, the UPS output and theinformation about the utility power, the battery, the UPS output and the
load could be displayed. The block of “INVERTER” indicates the inverterload could be displayed. The block of “INVERTER” indicates the inverter
is working. The operating mode code of the UPS is “02”.is working. The operating mode code of the UPS is “02”.
If output overloaded, the load percent is shown and alarm will keep twiceIf output overloaded, the load percent is shown and alarm will keep twice
every second. Yevery second. You should get rou should get rid of some id of some unnecessary loads one by onunnecessary loads one by onee
to decrease the loads connected to the UPS less than 90% of itsto decrease the loads connected to the UPS less than 90% of its
nominal pnominal power capacity.ower capacity.
Note:Note:Please follow the following steps to connect the generatorPlease follow the following steps to connect the generator
：：
●● Activate the generator and wait until the operation is stable beforeActivate the generator and wait until the operation is stable before
supplying power of the generator to the UPS (be sure that the UPS issupplying power of the generator to the UPS (be sure that the UPS is
in idle mode). Then turn on the UPS according to the start-upin idle mode). Then turn on the UPS according to the start-up
procedure. After the UPS is turned on, then the loads can beprocedure. After the UPS is turned on, then the loads can be
connected to the UPS one by one.connected to the UPS one by one.
Line modeLine mode
To Next Page
Loading...