3333
The display of battery test mode is same as Battery mode, but “H” andThe display of battery test mode is same as Battery mode, but “H” and
“L” would not be shown unless the input line voltage is higher or lower“L” would not be shown unless the input line voltage is higher or lower
than the SPEC range during the time of battery test. Tthan the SPEC range during the time of battery test. The operating modehe operating mode
code of the UPS is “03” in Battery mode, and the code is “04” in Batterycode of the UPS is “03” in Battery mode, and the code is “04” in Battery
TTest est mode.mode.
10.5 Parallel mode10.5 Parallel mode
If the UPS operate in parallel mode, the LCD display can show the UPSIf the UPS operate in parallel mode, the LCD display can show the UPS
quantity of the parallel system.quantity of the parallel system.
The LCD display in parallel mode is shown in the following diagram.The LCD display in parallel mode is shown in the following diagram.
When the UPS operating in parallel mode, the information in codeWhen the UPS operating in parallel mode, the information in code
display alternates between symbol “Pn” and Mode code. The symbol “P”display alternates between symbol “Pn” and Mode code. The symbol “P”
means the UPS operating in parallel mode, and the number “n” indicatemeans the UPS operating in parallel mode, and the number “n” indicate
the quantity.the quantity.
10.6 Warning mode10.6 Warning mode
The LCD display in warning mode is shown in the following diagram.The LCD display in warning mode is shown in the following diagram.
The information about the utility power, the battery, the UPS output andThe information about the utility power, the battery, the UPS output and
the load could be displayed. The symbol “MODE” not be shown and thethe load could be displayed. The symbol “MODE” not be shown and the
symbol “WARNING” is shown instead in code display.symbol “WARNING” is shown instead in code display.
Parallel modeParallel mode
To Next Page
Loading...