1 Technical specifications
Product description Electrically operated step for mounting externally under the
vehicle floor
Installation Externally under the vehicle floor below the front, middle or rear
door
Dimensions Step depth 300 mm, Step width 600, 900 or 1000 mm depending
on model
Please refer to the installation drawings for detailed dimensions
Weight 25-32 Kg depending on the model
Load Maximum load 200 Kg (2000 N). This is always labelled on the
Step
Materials Frame; steel plate work, EP corrosion protected
Step: Aluminum profile and Plastic corner covers
Life cycle Tested life cycle of the step is 150.000 cycles
Electrical connection Waterproof 4 pin connector (IP65)
Drive Electric motor 12V 20W
Electric signals Electric signals are available via dashboard light: Step moving /
open
Safety functions Motor switched off by current control.
Cycle time Time required for opening or closing the step is approx 2,5 Sec
Legislation The product fulfils R107 UN Bus directive and 98/37 EC Machine
directive.
To Next Page
Loading...