20
4. As soon as the beeping stops you hear a “clack” tone and a
double beep tone (the test is finished). If the breath sample
was not sufficient you will see „Flo“ on the display. Push the
start button and start a new test.
5. After a successful test the device is analyzing the breath
sample, you see several lines moving in clockwise circles
around the display. After a few seconds the test result is dis-
played for 5 seconds (with 3 digits and 2 decimals) in ‰, then
for 2.5 seconds in mg/L (= UK setting) and then for 2.5 seconds
in % BAC (with 4 digits and 3 decimals). If the test result is hig-
her than 0.50‰ or 0.25mg/L or 0.05% BAC, then you can hear
a warn signal (beep sound) for about 10 seconds.
Note: The device will turn off automatically if it is not in use for
about 3 minutes, additionally you hear a beep tone and on the
display you see „Out“ and afterwards „OFF“. If you want to con-
duct a new test, please press the power button. You can turn off
the device manually if you constantly press the power button for
about 5 seconds, you shortly see „OFF“ on the display and the
device turns off.
ACE Instruments recommends
Always use a new mouthpiece for each person and test that
is conducted. ACE Instruments assumes no liability for any
damages that may arise when several people use the same
mouthpiece for multiple tests.
Only use the provided individually packaged and hygienic
mouthpieces. During each test the breathalyzer’s internal
and external parts come into contact with human secretion
(saliva, blood, sweat, etc.)!
Use safety gloves when pulling out a mouthpiece used by an-
other person! You can buy appropriate gloves at ACE Technik
(www.ace-technik.de).
To Next Page
Loading...
