SORDIN TROUBLESHOOTING GUIDE
Thank you for choosing Sordin for your hearing protection needs! Ready to get out on the range or take a trip
to the woods for your next hunt, but having trouble with your hearing protector? Take a look at the following
information to help get your Sordin ready for duty.
BATTERY INSTALLATION – FIRST TIME USE
Open the battery cover on the left cup. Insert the battery with the (-) end first. It should fall into the compartment
and lie flat. If it does not fall into position, take a pen or pencil and gently push the battery in place. Insert the
second battery (+) end first, it should slide into place without any resistance.
IMPORTANT! – When screwing the battery cover back on, keep screwing until it is firmly closed but do not over-
tighten it. This may lead to damage of the battery contacts.
IS YOUR DEVICE NOT TURNING ON OR IS IT CONSTANTLY CUTTING OUT?
EXPERIENCING BAD SOUND QUALITY?
Make sure the battery cover is firmly secured, but not too tightly. If the batteries are not secured between the
contacts, they may not have the necessary contact required for operation.
Otherwise, it sounds like it is time to change the batteries. Make sure you change both batteries, the second
battery in the compartment can be easy to miss! Unscrew the battery cover and tilt the hearing protector dow-
nwards. The first battery should slide out. To remove the second battery, hit the top side of the cup against the
palm of your hand. You do not need a lot of force to dislodge the battery from its place.
Check out this video to see how batteries are installed and removed:
https://www.youtube.com/watch?v=XVcWlwdWtkg
To Next Page
Need help?
General