PROBLEM There is no picture on LCD Monitor
Troubleshooting
This LCD Monitor has pre-adjusted using factory standard VGA timings. Due to the output timing differences among
va
rious VGA cards in the market, users may initially experience an unstable or unclear display whenever a new
displa
y mode or new VGA cardis selected.
Attention
This LCD Monitor Supports Multiple VGA Modes. Refer to the Standard Timing Table for a listing of modes supported
by
this LCD Monitor.
The picture is unclear and unstable, please perform the following steps :
1.
Enter PC to "Shut Down Windows" status while you're in MS-Windows environment.
2.
Check the screen to see if there's any black vertical stripes appear. If there are,take advantage of the "Clock"
functio
n in OSD menu and adjust (by increment or decrement numbers)until those bars disappear.
3.
Move to "FOCUS" function in OSD menu again and adjust the monitor screen to its most clear display.
4.
Click "No" on "Shut Down Windows" and back to the normal PC operating environment.
If
there's no picture on the LCD Monitor, please perform the following steps:
1.
Make sure the power indicator on the LCD Monitor is ON, all connections are secured,and the system is running
on the correct timing. Refer to Chapte
r 3 for information on timing.
2.
Turn off the LCD Monitor and then turn it back on again. If there is still no picture,press the Adjustment Control
button several t
imes.
3.
If step 2 doesn't work, connect your PC system to another external CRT.If your PC system Functions properly with
a CRT Monitor but it does not function with the LCD Monitor,the output timing of the VGA card may be out of the
LCD'
s synchronous range.
Please change to an alternative mode listed in the Standard Timing Table or replace the VGA card,and then repeat
steps 1 and 2.
If
you have chosen an output timing that is outside of the LCD Monitor's synchronous range (Horizontal: 31.5 ~ 84 KHz
and
Vertical:56 ~ 86 Hz), the OSD will display a "Out of Range" message. Choose a mode that is supported by your
LCD
Monitor. Also, if the signal cable is not connected to LCD monitor at all or properly, the monitor screen will
displa
y
a message "No Input Signal".
Caution: Do not attempt to service the monitor yourself or open the computer yourself.
Please
refer all servicing to qualified service personnel if the problems cannot be solved in "Troubleshooting" section.
PROBLEM Picture is unclear and unstable
PROBLEM There is no picture on LCD Monitor
640*350@70Hz 800*449 31.469 P 70.087 25.175
EGA
720x400@70Hz 900*449 31.469 N 70.087 28.322
SVGA
832*624@75Hz 1152*667 49.725 N 74.550 57.283
XGA
1024*768@75Hz 1328*804 60.241 N 74.927 80.000
1152*870@75Hz 1456*915 68.681 N 75.062 100.00
VGA
640*480@66.7Hz
864*525
35.000
P 66.667 P 30.240
XGA
1024*768@72Hz
1360* 800
57.669 N
72.086
N
N
N
N
78.434
SXGA
1280*1024@70Hz 1696*1072 74.882 P 69.853
P
N
P
12
7.000
OTHER MODES
To Previous Page
Loading...
