12. Setup “Disk Configuration”. If you inserted more than one hard drive, you can select RAID 0 or
RAID 1. If you install over 3 HDDs, RAID 5 is enabled. When you are done with the setting, click
“Next”
Figure 1-14: Setup Disk Configuration
13. The storage will be divided into 2 portions: shared folders (default is 200MB) and backups, select
the desired volume for each one. When you are done, click “Finish”
Figure 1-15: Disk Space Distribution
Altos easyStore Quick Installation Guide
To Next Page
Loading...
