76 Chapter 5
3. Remove the battery.
4. Remove the memory module. Refer to page 30 for detailed instructions.
5. Locate the G91/G1 gap.
6. Use an electrical conductivity tool to short the two contacts on the hardware gap together.
7. While resting the tool on the two contacts, plug one end of the AC adapter into the DC power jack and
plug one end of the electrical outlet.
8. Press the power button to turn on the system.
9. After POST, remove the tool from the hardware gap.
10. Restart the computer. Press <F2> during bootup to access the BIOS Setup utility.
11. Press <F9> to load the system defaults.
12. Press <F10> to save the changes you made and close the Setup Utility.
Maintenance and Service Guide,Service Manual,Motherboard Schematics for Laptop/notebook http://faqp.ru/
HTTP://FAQP.RU/ - Схемы, сервис мануалы, инструкции по разборке ноутбука
To Next Page
Loading...
