2-28 System Utilities
LAN EEPROM Utilities 0
LAN EEPROM Utility enables to check and change the MAC address.
Perform the following steps to use the LAN EEPROM Utility:
To read the Mac address,
1. Create a DOS bootable USB HDD.
2. Copy the contents of the MAC folder to the HDD and remove the HDD form the computer.
3. Reboot the computer and press F2 during the boot sequence to enter the setup menu.
4. Select the Boot menu item and move the entry “USB HDD” to the first position. Refer to
Boot.
5. Insert the USB HDD and reboot the computer.
6. At the command prompt, navigate to the MAC folder.
7. Execute < ReadMAC.bat > to Read MAC address(Figure 2-30).
8. Reboot when the process has completed.
Figure 2-31. Read LAN MAC address
To Next Page
Loading...
