Acer B248Y - System Settings

System
Mode - Standard
HDMI
Picture
Color
Input
Full
Hot Key Assignment
DDC/CI
Wide Mode
On
On
Auto Source
Enter
Move
OSD
System
Save Sengs to...
Audio
Pertormance
Rest Reminder Off
Mode - Standard
C-Type
Picture
Color
USB Port Select
Off
Power-off
USB change
Enter
Move
OSD
System
Save Sengs to...
Audio
Pertormance
X
X
HDMI Black Level Normal
Quick Start Mode
Off
ProxiSense
Off
Daisy Chain
Off
USB 3.0
Off
1. Press the MENU key to open the OSD.
2. Toggle the joystick to the up or down to select System from the OSD.Then toggle to the
right to navigate to the element you wish to adjust and press the joystick to enter it.
3. Toggle to the left or right to adjust the sliding scales.
4. Input: Select the source from HDMI ,DP or DP ALT.
5. Auto Source: The default is “On”, which can support auto search for signal source in
order.
----------------------------------------------------------------------------------------------------------
Note: Surround application must set Auto Source is “Off”.
6. Daisy Chain: Default is Off, can select daisy chain function Extend or Clone. Clone
mode is not supported with AdaptiveSync.
7. Wide mode: You can select which screen aspect you are using. The options are
Aspect, Full, 1:1 and 21:9.
8. Hotkey Assigment: Hot Key 1 and Hot Key 2 can’t repeat the same function. Hot Key
1 default is (Modes), Hot Key 2 default is (Brightness). Because some functions limit
the Hot Key to be gray out and unavailable. Hot Key can dene of: (Modes, Brightness,
Volume, Gamma, Contrast, Low Blue Light, Over Drive).
9. DDC/CI: Allows the monitor settings to be set through the software on the PC.
-----------------------------------------------------------------------------------------------------------
Note: DDC/CI, short for Display Data Channel/Command Interface, which allows