47
9 Image is too small
or too large
• Adjust the zoom ring on the projector.
• Move the projector closer to or further from the
screen.
• Press "MENU" on the remote control. Go to "Image -
-> Aspect Ratio" and try different settings or press
"RATIO" on the remote control to adjust directly.
10 Image has slanted
sides
• If possible, reposition the projector so that it is
centered on the screen.
• Press the "Keystone / " button on the remote
control until the sides are vertical.
11 Image is reversed
• Select "Image --> Projection Mode" on the OSD and
adjust the projection direction.
12 LAN/WiFi, USB
Display source
show No signal
• Power off peojector and power on again.
13 Image hangs up
when displaying
photo or
document in
Media
• Power off peojector and power on again.
To Next Page
