21
EN
Insert the plastic part into the
designated slots along the plastic
frame.
on the back of the helmet fasten the
two plastic buttons.
6.1 INSTRUCTIONS dedicated TO peak AND TRANSPARENT VISOR
Remove the visor by unhooking it using
the special support.
Attach the visor using the special
support.
HOW TO REMOVE HOW TO INSTALL
6.2 INSTRUCTIONS dedicated to INNER LINING
Remove the back lining by pulling the
rear section to release the plastic
buttons.
Remove the front by gently releasing
the inside along the frame. To facilitate
the operation, start from the side of the
frame.
HOW TO REMOVE FROM THE BACK HOW TO REMOVE FROM THE FRONT
HOW TO ASSEMBLE FROM THE FRONT HOW TO ASSEMBLE FROM THE BACK
To Next Page
Loading...