ACHATE MS-100 - Product Application Method; Product Installation

14 15
PRODUCT APPLICATION METHOD
1. Turn off the appliance when adding water to the product.
2. Use the product carefully because of the high temperature of the steam generated by the
steam mop to avoid burns.
3. Do not add chemical solvents such as as detergent, perfume, essential oil, etc.
4. Let the steam run for 1 minute when using the product again after a long time.
PRODUCT INSTALLATION
1. Installation of the steam swab handle and connection to the
host circuit. Push the metal tube installation hole toward the
metal tube mounting column according to Figure 1 and push
the metal tube mounting column inward to ensure that the
metal tube is forced downward.
2. Installation of the cleaning cloth Pat the cleaning element
horizontally on the base plate and raise the easy-tilt strap.
3. Application method of the duster to the mop Place the
device over the duster, then press the duster inward until the
duster sticks to the duster.
4. WateringmethodofwatertankRemovetheinowcapfrom
the water tank outward out. Tilt the machine properly,
 measurethepuriedwaterwiththemeasuringcupand 
 pouritintothewatertank,thensnaptheowplugofthe
water reservoir into the hole of the water reservoir and
replace the cap.
5. Take-up method of power cord Bundle the power cord with a
cable tie and then hang it from the hook on the handle, as
shown in the illustration.