Quick Start Guide
2019/09
Documentation and Support
For the full set of FreeShape 120 documentation, go to:
https://ackuretta.com/support-center/freeshape120
For community feedback, see our Ackuretta’s User Group on Facebook:
https://www.facebook.com/groups/2164055477166718/
www.ackuretta.com
Setting Up Wi-Fi
You can easily operate your FreeShape 120 from your computer. You can upload prints
directly, and track print status. To set up your Wi-Fi connection:
1. Go to Network.
2. Select Wi-Fi.
3. Turn Wi-Fi Connection to “ON”.
4. Select your Wi-Fi network.
5. An IP address will appear. Key the IP address
into a browser on your computer.
Wi-Fi setup video:
https://youtu.be/6UzuHPnGYnI
Updating Firmware
Ackuretta is always adding new resins and improving functionality. If you are connected to
the Internet, check for the latest firmware:
1. Go to Settings.
2. Select Update.
3. Press Update firmware online.
Update firmware video:
https://youtu.be/C3ThWRO56vk
Print
You can print either over Wi-Fi or from your USB device.
1. Go to Print.
2. Choose USB or Computer, depending on your
location of your file.
3. Choose your IBF file.
4. Change your material setting, if necessary.
5. Press Print.
Print video:
https://youtu.be/3iRLnvvCwck
To Next Page
Need help?
General
