ACME MP-12FC - Display, Inversion, and Color Adjustments

Blackout mode
Press the MENU button up to when the
is shown on the display. Pressing ENTER
button, Use DOWN and UP button to select the
(blackout) or (normal).
Once select, press ENTER button to setup or automatically exit menu mode without any
change after 7seconds. To go back to the functions without any change press the MENU
button
LED display
Press the MENU button up to when the
is shown on the display. Pressing ENTER
button and the display will blink. Use DOWN and UP button to select
(display
always on) or
(display off 20 seconds after exit menu) mode. Once select, press
ENTER button to setup or exit menu mode without any change after 7seconds. Back to the
functions without any change press MENU button again.
Display Inverse
Press MENU button until
is blinking on the display. Use DOWN and UP button to
select
(display normal) or (display inverse), press ENTER button to setup.
Back to the functions without any change press MENU button.
White Balance
Press the MENU button up to when the
is shown on the display. Pressing ENTER
button, and use DOWN and UP button to select
, or , press ENTER
button to confirm and use DOWN and UP button to adjust the value between 125 and 255,
once select press ENTER button to setup or automatically exit menu mode without any
change after 7seconds. To go back to the last function without any change press the MENU
button.
Manual setting color
Press the MENU button up to when the
is shown on the display. Pressing ENTER
9 A