9
GB
Driver Function Test
• You can set the original dead zone for wheel direction (X axis), gas (Y+ axis), brake (Y-axis) as
below. (see picture 5 “Dead Zone setup”)
• Wheel sensitivity can be adjusted from low to high in dierent degrees as below. (see Picture 5
“sensitivity setup”)
• Wheel acceleration, brake and key 1 to key 12 is interchangeable (key mapping). (See Picture 5
“KeyMap setup” as below.)
• When driver is installed, default is set the rst time you press the MODE button. There is no need
for a manual calibration.
Note: The rst time you press the wheel MODE button, please do not press any other buttons
• Auto Cruise Setup and Cancel
Depress the gas pedal to any position. Press the CRUISE button. Then release the pedal. The
gas volume will be recorded and functioning for auto cruise. When brake or gas control is out
of the volume, auto cruise function will be cancelled and normal operation will be active
To Next Page
Loading...