To Next PageTo Next PageWhat to do if the ACOPOWER Midas Y Inverter load is no output and the load and fault icon blink?
If the load is overloaded, reduce the number of electrical devices. Then, restart the controller and wait for one night-day cycle (night time>3 hours).
What does it mean when the battery indicator on my ACOPOWER Midas Y Inverter is red and slow flashing?
A red slow flashing battery indicator, along with a blinking battery frame and fault icon, indicates that the battery is overheating. The controller will automatically turn the system off. When the temperature declines to below 55 ºC, the controller will resume.
What to do if the ACOPOWER Inverter charging indicator is Green fast flashing?
If the charging indicator is flashing green rapidly, the battery level shows full, and the battery frame and fault icon are blinking, it means the battery voltage is too high. Check if the battery voltage is higher than the over voltage disconnect voltage, and disconnect the PV.
Read instructions and warnings. Do not disassemble. Mount indoors, well ventilated.
Specifies PV module connection requirements, series/parallel configurations, and voltage limitations.
Details recommended wire sizes for PV, battery, and load connections based on model and current.
Covers supported battery types (Lead-acid, Lithium) and user-definable settings for voltage control.
Explains different load operating modes, including LCD settings and timer-based control options.
Details the controller's built-in protections against PV overcurrent, reverse polarity, over/under voltage, and overheating.
Provides a guide to identify and resolve common issues like PV disconnection, battery voltage problems, and indicator faults.
Lists key electrical specifications including voltage, current, power, efficiency, and operating ranges for MY20, MY30, MY40.
General