AcousticSheep SleepPhones Classic User Manual

/
SleepPhones
®
and RunPhones
®
Classic
(Wired Headphones)
Headband
Speakers and Cord
SLEEPPHONES
®
OR RUNPHONES
®
CLASSIC
/ /
WEARING YOUR CLASSIC HEADPHONES
Please Note: The speakers move inside of the headband,
independently of the headband.
Holding the headband, you’ll notice the at
speakers – one on each side – inside of the
headband.
Place the headband on your head (tag towards
the back).
Once the headband is on, adjust the speakers
so they are positioned directly over your ears.
This will ensure the best sound quality.
1
2
3
R
L
3.5 mm
WASHING INSTRUCTIONS
Open the hook and loop at the
back of the headband to reveal
the speaker components inside
the headband.
Reach in to remove the
speakers, one at a time,
from the headband.
Once the speakers are
removed, you can machine-
wash the headband.
Reinsert one speaker at a time,
and move each about four inches from
the hook and loop opening on either side
of the headband.
• Right speaker has red stitching
• Left speaker has green stitching
• Softer gray side should face towards the ear
• White side should face away from the ear
Close the hook and loop opening with the cord hanging
out so you can connect to your device.
1
2
3
4
5
• When disconnecting the cord, grasp and pull the plug
and not the cord.
• Do not leave components in a wet or dirty headband.
• Wash your headband regularly (remove all components
before washing).
• Avoid bending near the plug and keep the cord free of
tangles and knots.
PROLONG THE LIFE OF YOUR HEADPHONES
R
L
INSTRUCTIONS
Scan this QR code or visit www.SleepPhones.com/instructions
to read this User Guide as well as Warranty Information and
Legal disclosures in additional languages.
ANLEITUNG
INSTRUCCIONES
ISTRUZIONI
INSTRUÇÕES
說明書
说明书
指示書
명령
تعليمات

AcousticSheep SleepPhones Classic Specifications

General

Connectivity	Wired
Material	Fleece
Impedance	32 ohms
Driver Type	Dynamic
Frequency Response	20 Hz - 20 kHz
Connector	3.5 mm
Wireless	No
Noise Cancelling	No
Microphone	No
Compatibility	Any device with a 3.5mm headphone jack
Cable Length	3.5 ft

Summary

WEARING YOUR CLASSIC HEADPHONES

Identify and Hold Speakers

Locate flat speakers inside the headband and hold them for proper placement.

Position Headband Correctly

Place the headband on your head with the tag positioned towards the back.

Align Speakers for Best Sound

Adjust speakers to sit directly over your ears for optimal sound quality.

WASHING INSTRUCTIONS

Remove Speaker Components

Open the headband hook and loop to remove speaker units before washing.

Reinsert Speakers Properly

Reinsert speakers, noting stitching and orientation for correct placement.

Close Headband and Connect

Secure the headband, ensuring the cord hangs out for device connection.

PROLONG THE LIFE OF YOUR HEADPHONES

Handle Cord Carefully

Grasp the plug, not the cord, when disconnecting to prevent damage.

Maintain Headband Cleanliness

Do not leave components in a wet headband and wash regularly.

Prevent Cord Tangles and Bends

Avoid bending the plug and keep the cord free of tangles and knots.

WARRANTY AND LEGAL INFORMATION

Safety Warnings and Hearing

Covers strangulation hazards and hearing damage risks from high volume exposure.

Customer Service and Support

Contact information for assistance and links to FAQs for setup help.

Limited One-Year Warranty

Details the limited warranty period and directs users to the website for full terms.