ACPro Q7RE Series User Manual

14 SEER
Single Package Heat Pump - Single Stage, R-410A
*Q7RE SERIES
INSTALLATION INSTRUCTIONS
IMPORTANT
ATTENTION INSTALLERS:
It is your responsibility to know this product better than your customer. This includes being
able to install the product according to strict safety guidelines and instructing the customer on
how to operate and maintain the equipment for the life of the product. Safety should always be
the deciding factor when installing this product and using common sense plays an important
role as well. Pay attention to all safety warnings and any other special notes highlighted in the
manual. Improper installation of the furnace or failure to follow safety warnings could result in
serious injury, death, or property damage.
These instructions are primarily intended to assist qualified individuals experienced in the proper
installation of this appliance. Some local codes require licensed installation/service personnel
for this type of equipment. Please read all instructions carefully before starting the installation.
Return these instructions to the customer’s package for future reference.
DO NOT DESTROY. PLEASE READ CAREFULLY & KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.

ACPro Q7RE Series Specifications

General

Brand	ACPro
Model	Q7RE Series
Category	Heat Pump
Language	English

Summary

Important Safety Information

Electrical Shock, Fire, Explosion Hazards

Electrical shock, fire, and explosion hazards with specific warnings for servicing.

R-410A Refrigerant Warnings

Warnings regarding R-410A refrigerant handling and installation by qualified personnel.

Combustible Material Warning

Caution against placing combustible materials near the unit.

Proposition 65 Warning

California Proposition 65 warning regarding fiberglass wool exposure.

General Installation Precautions

General safety recommendations for installation and unqualified individuals.

Requirements & Codes

Heat Pump Installation

Electrical Connections

Pre-Electrical Checklist

Line Voltage Supply

Guidelines for connecting line voltage, including disconnect requirements and wire types.

Overcurrent Protection

Grounding Requirements

Importance of proper grounding and avoiding gas piping for electrical grounding.

Thermostat Wiring

Startup & Adjustments

Pre-Start Checklist

Unit Start-Up Procedure

Step-by-step guide for energizing and verifying unit operation in cooling mode.

System Operation Tests

Control Board Tests and Modes

Unit Maintenance

Routine Maintenance Guidelines

Refrigerant Charging

AC Mode Charging Procedure

Steps for charging the unit in cooling mode based on outdoor temperatures.

Heating Mode Charging Procedure

Procedures for charging the unit in heating mode, emphasizing verification in cooling.

Installation Checklist