1. Connect the OLAS app to the Guardian. For more
information on how to do this please refer to the
Guardian Setup Instructions.
Testing the alarm
2. Ensure all OLAS transmitters are seen on the OLAS app
homescreen.
3. Switch off the OLAS transmitters.
OLAS tag: press the button for 4 seconds, until a red flash
is seen. OLAS Float-On: press the button for 4 seconds
until the bicolor LED flashes red.
4. The alarm will occur after your set ‘Alert Time’ and the
engine will cut out. The default Alert Time is 2 seconds.
5. Press the Guardian’s control switch once or tap
"Continue to Recovery" in the App. This puts the system
into pause state.
6. Press the control switch again once. 3 beeps will sound
to indicate that the transmitter is still missing, and the
system is still in pause state.
Press and hold the MOB button
on your GPS Chart Plotter
Press and hold the MOB button
on your GPS Chart Plotter
OR
www.acrolas.com
To Next Page
