1. Accept the alarm with the ACR OLAS App.
Troubleshooting
2. Bring the Tag within 1 meter of the Guardian.
3. Cancel the alarm on the Guardian by pressing the
control switch once. After 10 seconds the system will be
tracking again.
4. Navigate to the Alert Settings in the ACR OLAS App.
5. Adjust the Alert Delay to 4 seconds. This means if the
connection between the Tag and the Guardian is broken
for longer than 4 seconds the alarm will sound.
6. Walk to the location where the Tag previously set off
the alarm and then continue walking around the vessel.
If you experience a false alarm whilst testing the system, it is likely because the connection between the Tag and the
Guardian was broken for longer than 3 seconds. If this occurs carry out the following steps to adjust your system.
10s
Press and hold the MOB button
on your GPS Chart Plotter
www.acrolas.com
To Next Page
Need help?
General
