Ai C20 RECIRCULATING CHILLER USER’S MANUAL
11
7.1 Basic Setting: Target Temperature
7.1.1 Make sure all fluid connections are secured, and the fluid level is proper.
7.1.2 Plug in the power cord
7.1.3 Flip the circuit breaker on.
7.1.4 If you hear any buzzing sound, then press any button to clear it.
7.1.5 Press “SET” once and set your target temperature in the “TEM Setting” section. Use “LEFT”, “UP”, or
“DOWN” to adjust the temperature setting and press “SET” again to confirm.
7.1.6 Set your timer setting in the “Timing” section. Use “LEFT”, “UP”, or “DOWN” to adjust the temperature
setting and press “SET” again to confirm and return to main screen. When timer is up, controller will
display “END”, then chiller stops, and you will hear a buzzing sound, press any button to clear it. If the
timer is set to 0, then chiller will run continuously until the chiller is stopped manually by the user (See
picture 1).
Picture 1
To Next Page
Loading...