Need help?Do you have a question about the ACS CFSound-IV and is the answer not in the manual?
General| Brand | ACS |
|---|---|
| Model | CFSound-IV |
| Category | Stereo System |
| Language | English |
Details the ten-pin, 2-piece pluggable terminal block connector for primary connections.
Specifies the required regulated or unregulated DC voltage and connection points.
Details connecting the CFSound-IV to a PC via RS-232, including cable requirements and flow control.
Explains Ethernet connectivity, network speeds, and supported protocols.
Details USB connectivity for flash drive or serial device modes.
Provides steps to diagnose issues when no sound or LEDs are active.
Guides on troubleshooting when the Red LED flashes, indicating an error.
Specifies the type and format requirements for SD and SD-HC flash cards.
Details the correct file systems (FAT16/FAT32) for formatting SD cards.
Explains the Media Access Control address, its uniqueness, and format.
Details the Internet Protocol address, its structure, and private network ranges.
Explains subnetting and how IP masks divide network addresses.
Details operation controlled by sound file names and contact associations.
Explains the DOS 8.3 naming convention for sound files.
Details how to enable and configure Quiz or Kiosk modes using the INI file.
Explains configuring sequential sound playback triggered by contact closures.
Describes the ASCII protocol used for serial commands to control sound playback.
Explains how the CFSound-IV acts as a DMX controller using Art-Net.
Details how the CFSound-IV acts as a DMX device receiving commands via Art-Net.
Describes the status indications provided by the Green LED.
Explains the error codes indicated by Red LED flashing patterns.
Details the idle and active power consumption of the unit.
Provides guidelines for recording high-quality audio for the system.
Details how to record audio directly into WAV files on the SD card.
To Next Page