Need help?Do you have a question about the Actisense NGX-1-ISO and is the answer not in the manual?
Covers accuracy, operation, and code of practice warnings for safe and correct use.
Addresses warnings related to device mounting locations and firmware update procedures.
Details compliance with FCC rules for digital devices and radio frequency exposure.
Outlines compliance with Industry Canada's RSS standards and digital apparatus regulations.
Describes the two operational modes: Transfer and Convert, and their functionalities.
Explains the differences and features of the NGX-1-ISO and NGX-1-USB variants.
Guides on powering, connecting to USB/NMEA 2000 networks, and driver installation.
Details connecting the NGX-1-ISO to NMEA 0183 devices in Convert Mode.
Covers installing the NGX-1-USB as a NMEA 2000 gateway in Transfer Mode.
Explains how to swap between Transfer/Convert modes and alter baud rates.
Guides on using Actisense Toolkit for settings and updating device firmware.
Explains the behaviour of NMEA 2000 Tx/Rx LEDs for device status indication.
Describes the status indicated by ISO/USB Tx/Rx LEDs for different modes.
Details power supply, port compatibility, mechanical properties, and physical dimensions.
Lists module certifications, EMC, environmental protection, and operating conditions.
General| Type | NMEA 2000 to NMEA 0183 Gateway |
|---|---|
| Input Protocols | NMEA 2000 |
| Output Protocols | NMEA 0183 |
| NMEA 0183 Ports | 1 |
| NMEA 2000 | Yes |
| Environmental Protection | IP67 |
| Weight | 150g |
| Isolation | Galvanic Isolation on NMEA 0183 port (2500V) |
To Next Page
