Acuity Brands Lithonia Lighting Quantum ELM6 LED - User Manual

INSTALLATION INSTRUCTIONS
ELM6 LED
When using electrical equipment, basic safety precautions
should always be followed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY OR SIGNIFICANT
PROPERTY DAMAGE - For your protection, read and follow these warnings and instructions carefully before installing or maintaining this
equipment. These instructions do not attempt to cover all installation and maintenance situations. If you do not understand these instructions or
additional information is required, contact Lithonia Lighting or your local Lithonia Lighting distributor.
WARNING: RISK OF ELECTRIC SHOCK – NEVER CONNECT TO, DISCONNECT FROM OR SERVICE WHILE EQUIPMENT IS ENERGIZED.
WARNING: DO NOT USE ABRASIVE MATERIALS OR SOLVENTS. USE OF THESE SUBSTANCES MAY DAMAGE FIXTURE, WHICH MAY
RESULT IN PERSONAL INJURY.
WARNING: RISK OF PERSONAL INJURY – This product may have sharp edges. Wear gloves to prevent cuts or abrasions when removing
from carton, handling, installing and maintaining this product.
• Before wiring to power supply, turn off electricity at fuse or circuit breaker.
• Disconnect A.C. power before servicing.
• All servicing should be performed by qualified personnel.
• Consult your local building code for approved wiring and installation.
• Do not use outdoors.
• Do not mount near gas or electric heater.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS
AND DELIVER TO OWNER AFTER INSTALLATION
!
!
!
!
IMPORTANT SAFEGUARDS
US Patent No. D483,511
EMERGENCY LIGHTING UNITS
Press latches to disengage
housing from mounting plate
“TEST” button /
status indicator

Summary

Important Safety Instructions

General Safety Precautions

Covers essential safety precautions, including warnings about electrical shock, proper handling, and avoiding specific materials.

Specific Safety Warnings

Details critical warnings regarding electric shock, abrasive materials, sharp edges, and usage limitations.

Installation and Wiring Guide

Mounting and Power Supply Setup

Instructions for mounting the unit on junction boxes and connecting the AC power supply.

Wiring Diagram and Connections

Visual guide and notes for correctly wiring the unit, including remote lamp options.

Securing Housing and Plate

Guidance on attaching the housing to the mounting plate, ensuring secure latch engagement.

Testing Procedures

Operational and Manual Testing

Details on battery charging requirements and how to perform normal and manual tests.

Maintenance and Compliance

Component Replacement

Instructions for replacing the battery, lamp assembly, and charger board.

Battery Care and FCC Compliance

Information on battery lifespan, initial charging, and adherence to FCC regulations.

Acuity Brands Lithonia Lighting Quantum ELM6 LED Specifications